Moxa Technologies ETHERDEVICE EDS-305 Installation Guide

MOXA EtherDevice Switch EDS-308/305 Hardware Installation Guide First Edition, June 2003 Moxa Technologies Co., Ltd.Tel: +8

— 9 —SC-Port Pinouts SC-Port to SC-Port Cable Wiring Redundant Power Inputs Both power inputs can be connected simultaneously to live

— 10 —LED Indicators The front panel of MOXA EtherDevice Switch contains several LED indicators. The function of each LED is described in the table

— 11 —Fiber Ports MOXA EtherDevice Switch’s fiber switched ports operate at a fixed 100 Mbps speed and full-duplex mode to provide the best perf

— 12 —Auto-Negotiation and Speed Sensing All of MOXA EtherDevice Switch’s RJ45 Ethernet ports independently support auto-negotiation for speeds in t

— 13 —Overload Current Protection 1.1 A (EDS-305, EDS-305-M, EDS-305-S, EDS-308) 1.6 A (EDS-308-M, EDS-308-S, EDS-308-MM, EDS-308-SS) Reverse Po

— 14 —Power supply lines+/- 2 KV 3 Comm. lines +/- 1 KV 3 IEC 61000-4-4 Burst (Fast Transient) Relay +/- 1 KV 3 Power supply lines+/- 2 KV, 12Ω

— 15 —MOXA Internet Services Customer satisfaction is our number one concern, and to ensure that customers receive the full benefit of our produ

— 1 —Overview The MOXA EtherDevice™ Smart Switches, EDS-308/305 Series, are 8- and 5- port Ethernet Switches that provide an economical solution for

Panel Layout of EDS-305 series 1. Grounding screw 2. Terminal block for power input P1/P2 and relay output 3. Heat dissipation orifices 4. Dip

Panel Layout of EDS-308 series 1. Grounding screw 2. Terminal block for power input P1/P2 and relay output 3. Heat dissipation orifices 4. Dip

Mounting Dimensions DIN-Rail Mounting The aluminum DIN-Rail attachment plate should already be fixed to the back panel of EDS when you take it out

STEP 1: Insert the top of the DIN-Rail into the slot just below the stiff metal spring. STEP 2: The DIN-Rail attachment unit will snap into place a

STEP 3: Once the screws are fixed in the wall, insert the four screw heads through the large parts of the keyhole-shaped apertures, and then slide M

Wiring the Alarm Contact The Alarm Contact consists of the two middle contacts of the terminal block on EDS’s top panel. You may refer to the next se

— 8 —Communication Connections EDS-308 models have 6, 7, or 8 10/100BaseT(X) Ethernet ports, and 2, 1, or 0 (zero) 100 BaseFX (SC-type connector) fi