Moxa Technologies EtherDevice Installation Guide download pdf (Page 5)

- 5 -

DIN-Rail Mounting

The plastic DIN-Rail attachment plate should already be fixed to the rear panel

of the EDS when you take it out of the box. If you need to reattach the

DIN-Rail attachment plate, make sure the DIN-Rail kit is situated towards the

top, as shown in the figures below.

STEP 1:

Insert the top of the DIN-Rail into

the slot.

STEP 2:

The DIN-Rail attachment unit will

snap into place as shown below.

To remove Moxa EDS-205 from the

DIN-Rail, insert a flat-blade screw

driver horizontally into the DIN-Rail

kit under the EDS-205, and then pull

it upwards and release the EDS

towards you and away from the

DIN-Rail.

Wiring Requirements

Safety First!

Be sure to disconnect the power cord before installing and/or

wiring your Moxa EtherDevice Switch.

Calculate the maximum possible current in each power wire and

common wire. Observe all electrical codes dictating the

maximum current allowable for each wire size.

If the current goes above the maximum ratings, the wiring could

overheat, causing serious damage to your equipment.

1 2 3 4 5 6 7 8 9 10 11

No comments

Moxa Technologies EtherDevice Installation Guide Page 5