UC-8410/8416/8418/8430 Hardware User's Manual Hardware Connection Description
4-4
Connecting to the Network
Connect one end of the Ethernet cable to one of the UC-8410/8416/8418/8430’s 10/100M Ethernet ports
(8-pin RJ45) and the other end of the cable to the Ethernet network. If the cable is properly connected, the
UC-8410/8416/8418/8430 will indicate a valid connection to the Ethernet in the following ways:
The lower right corner LED indicator maintains a
when the cable is properly connected to a 100 Mbps Ethernet
network. The LED will flash on and off when Ethernet packets are
being transmitted or received.
Pin Signal
1 ETx+
2 ETx-
3 ERx+
4 –
5 –
6 ERx-
7 –
8 –
The lower left corner LED indicator maintains a
when the cable is properly connected to a 10 Mbps Ethernet
network. The LED will flash on and off when Ethernet packets
being transmitted or received.
The UC-8416 has 8 10/100 Mbps switch ports. The LED indicators and pin assignments are
exactly the same as the Ethernet ports.
Connecting to a Serial Device
Use properly wired serial cables to connect the UC-8410/8416/8418/8430 to serial devices. The
UC-8410/8416/8418/8430’s serial ports (P1 to P8) use 8-pin RJ45 connectors. The ports can be configured by
software for RS-232, RS-422, or 2-wire RS-485. The precise pin assignments are shown in the following table:
Pin RS-232 RS-422/
RS-485-4w
RS-485-2w
1 DSR – –
2 RTS TXD+ –
3 GND GND GND
4 TXD TXD- –
5 RXD RXD+ Data+
6 DCD RXD- Data-
7 CTS – –
8 DTR – –
Comments to this Manuals