Moxa Technologies TN-5510-2GLSX-ODC Installation Guide

 2012 Moxa Inc. All rights reserved. Reproduction without permission is prohibited. P/N: 1802055100041 TN-5510-2GLSX-ODC Hardware Instal

- 10 - ATTENTION This product is intended to be mounted to a well-grounded mounting surface such as a metal panel. Connecting the Power Supplies Th

- 11 - STEP 1: Plug your power cord’s M23 connector to the power input port of the TN-5510 switch. STEP 2: Screw the nut on your power cord connect

- 12 - Connecting the Data Lines 10/100BaseT(X) Ethernet Port Connection All TN-5510 models have 8 10/100BaseT(X) Ethernet ports (4-pin shielded M12

- 13 - M12 (4-pin, M) to M12 (4-pin, M) Straight-Trough Cable Wiring M12 (4-pin, M) to RJ45 (8-pin) Cross-Over Cable Wiring M12 (4-pin, M) to RJ4

- 14 - NOTE 1. “Hardware-based IP configuration” only supports IPv4 address settings. 2. “Hardware-based IP configuration” is enabled only when t

- 15 - OFF When the TN switch is neither the Master of this Turbo Ring, nor the Head of this Turbo Chain. CPLR/ TAIL GREEN ON When the TN switch en

- 16 - Interface Fast Ethernet Front cabling, M12 connector, 10/100BaseT(X) auto negotiation speed, F/H duplex mode, and auto MDI/MDI-X connection Gi

- 17 - Technical Support Contact Information www.moxa.com/support Moxa Americas: Toll-free: 1-888-669-2872 Tel: 1-714-528-6777 Fax: 1-714-528-6

- 2 - Overview The ToughNet TN-5510-2GLSX-ODC series M12 managed Ethernet switches are designed for industrial applications in harsh environments. Th

- 3 - • Lock port allows access by only authorized MAC addresses. • Port mirroring for online debugging. • Automatic warning by exception through

- 4 - TN-5510-2GLSX-ODC Panel Layouts 1. 3 Rotary switches and protective cover with Model name. 2. Screw holes for panel mounting kit. 3. Consol

- 5 - 8. PWR1 LED: for power input 1. 9. PWR2 LED: for power input 2. 10. FAULT LED. 11. MSTR/HEAD LED: for ring master or chain head. 12. CPLR/

- 6 - Mounting Dimensions (unit = mm) TN-5510-2GLSX-ODC Series

- 7 - Panel/Wall Mounting STEP 1: Mounting the TN-5510 to a wall requires 4 screws. Use the ToughNet switch as a guide to mark the correct positions

- 8 - DIN-Rail Mounting (optional) Use a pair of optional DK-DC50131 DIN-Rail mounting kits (must be purchased separately) to mount the TN-5510 on a

- 9 - Wiring Requirements WARNING Turn the power off before disconnecting modules or wires. The correct power supply voltage is listed on the produc