Moxa Technologies DE-304 Installation Guide download pdf (Page 13)

2-5

The next step is to attach NPort Server Lite to the Din Rail.

STEP 1: Insert the top of the DIN Rail

into slot A of the DIN Rail

mount.

STEP 2: Push the bottom of NPort

Server Lite so that the bottom

of the DIN Rail snaps into

slot B of the DIN Rail mount.

To remove NPort Server Lite from the DIN Rail, simply reverse Steps 2 and 3

above by grasping the bottom of the NPort Express device server with both

hands, and then using your fingers to pull down slightly on the DIN Rail mounts

at slot B. This releases the bottom of the DIN Rail from the DIN Rail mount.

Network Connection

There are two ways to use the 10/100BaseT Ethernet jack located on NPort

Server Lite’s rear panel.

1. For many of the applications using NPort Server Lite, you will simply plug

one end of your Ethernet cable into the 10/100BaseT jack, and the other end

into the hub connected to your network. In this case, use a standard

straight-through Ethernet cable.

2. In some cases, such as when configuring drivers and software, you will find

it convenient to hook NPort Server Lite directly to your computer’s Ethernet

card. To do this you will need to use a cross-over Ethernet cable, such as the

one supplied with your server.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 32 33

No comments

Moxa Technologies DE-304 Installation Guide Page 13