Moxa Technologies EtherDevice Installation Guide download pdf (Page 11)

- 11 -

Please read and follow these guidelines:

y Use separate paths to route wiring for power and devices. If power wiring

and device wiring paths must cross, make sure the wires are perpendicular

at the intersection point.

NOTE: Do not run signal or communications wiring and power wiring

through the same wire conduit. To avoid interference, wires with different

signal characteristics should be routed separately.

y You can use the type of signal transmitted through a wire to determine

which wires should be kept separate. The rule of thumb is that wiring

sharing similar electrical characteristics can be bundled together

y You should separate input wiring from output wiring

y We advise that you label the wiring to all devices in the system.

Grounding the Moxa EDS-600

EDS switches are designed to enhance EMS performance by grounding. EDS

switches come with metal DIN-Rail brackets for grounding the switches. For

optimal EMS performance, connect the chassis ground nut on the switch to

the grounding point.

ATTENTION

This product is intended to be mounted to a well-grounded

mounting surface such as a metal panel.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

No comments

Moxa Technologies EtherDevice Installation Guide Page 11