Moxa Technologies CP-118EL User Manual download pdf (Page 14)

PCI Express Board User's Manual Hardware Installation

2-6

CP-114EL-I Dimensions

Plugging the Board into an Expansion Slot

Since the BIOS automatically assigns the PCI Express board’s IRQ number and I/O addresses, you must plug

the board into one of the computer’s expansion slots before installing the driver.

Step 1: Power off the PC.

WARNING

To avoid damaging your system and board, make sure you turn off your computer before installing the board.

Step 2: Remove the PC’s cover.

Step 3: Remove the slot cover bracket if there is one.

Step 4: Plug the PCI Express board firmly into a free PCI Express slot.

Step 5: Fasten the holding screw to fix the control board in place.

Step 6: Replace the PC’s cover.

Step 7: Power on the PC. The BIOS will automatically set the IRQ and I/O address.

NOTE

Each Moxa PCI Express board uses one unique IRQ and I/O address, both of which are assigned automatically

by the PCI BIOS.

Step 8: Proceed with the software installation discussed in the next chapter, “Software Installation.”

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 93 94

No comments

Moxa Technologies CP-118EL User Manual Page 14