Moxa Technologies NPort 5200 Serie User Manual download pdf (Page 26)

SDK 2 Programmer’s Guide Developing User Applications

3-17

Use the Open button to navigate to the

folder that contains the kernel file, or just

type the kernel filename directly in the

Filename input box. Click OK to start

downloading the kernel. The following

window appears when the kernel has

finished downloading.

Run Application / Debug

You should now be ready to run your application, but first we need to discuss the two NPort PCG

operation modes.

Choose Running Mode or Developing Mode

NPort 5200-P provides two operation modes, which are selected by jumper (jumper JP4 for NPort

5210; jumper JP2 for NPort 5230). The jumpers are located on NPort 5200-P’s circuit board, so to

select between the two modes, first remove the outer cover.

Developing Mode

NPort 5210: Short jumper JP4

NPort 5230: Short jumper JP2

When set for Developing Mode, the PCG will not start running the application automatically after

the system is rebooted. To start the application, select Run Application / Debug from the Actions

menu, or click on the Run Application / Debug toolbar icon. We suggest setting the operation

mode to Developing Mode when going through the debugging process.

Running Mode

NPort 5210: Do NOT short jumper JP4

NPort 5230: Do NOT short jumper JP2

When set for Running Mode, the PCG automatically executes the application after the system

boots up. However, you can stop the application from within SDK Manager. This mode is suitable

for regular shipment.

NOTE

NPort PCG 5200-P servers are set to Running Mode by default.

NPort PCG 5200-ST servers are set to Developing Mode by default.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 36 37

No comments

Moxa Technologies NPort 5200 Serie User Manual Page 26