Moxa Technologies 331 User Manual download pdf (Page 10)

UC-7112-LX Plus Software User’s Manual Getting Started

2-2

Powering on the UC-7112-LX Plus

Connect the SG wire to the shielded contact located on the terminal block in the left corner of the

UC-7112-LX Plus, and then power on the computer by connecting it to the power adaptor. It takes

about 30 to 60 seconds for the system to boot up. Once the system is ready, the Ready LED will

light up.

NOTE After connecting the UC-7112-LX Plus to the power supply, it will take about 30 to 60 seconds

for the operating system to boot up. The green Ready LED will not turn on until the operating

system is ready.

ATTENTION

This product is intended to be supplied by a Listed Power Unit with output marked “LPS” and

rated for 12-48 VDC, 340 mA (minimum requirements).

Connecting the UC-7112-LX Plus to a PC

There are two ways to connect the UC-7112-LX Plus to a PC: (1) through the serial console, and

(2) by Telnet over the network.

Serial Console

The serial console gives users a convenient way of connecting to the UC-7112-LX Plus. This

method is particularly useful when using the computer for the first time. The serial console is

useful for connecting the UC-7112-LX Plus when you do not know either of the two IP addresses.

Use the serial console port settings shown below.

Baudrate

115200 bps

Parity

None

Data bits

Stop bit(s)

Flow Control

None

Terminal

VT100

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 100 101

No comments

Moxa Technologies 331 User Manual Page 10