CN2610 User’s Manual Setting Up DRDAS
7-5
+-----------------------------------------------------+
| TCP data port : [955] |
| TCP command port : [971] |
| Primary IP addr : [ ] |
| Backup 1 IP addr : [ ] |
| Backup 2 IP addr : [ ] |
| Backup 3 IP addr : [ ] |
| TCP alive check time : [0 ] minutes |
+-----------------------------------------------------+
Setting Value Notes Necessity
TCP data port number Via the data port, users can retrieve data through
the async line.
Yes
TCP command
port
number Via the command port, users can issue commands
across the network to set the line’s configuration
parameters, such as baudrate, data bits, flow
control condition, etc.
Yes
Primary IP addr IP address The primary host’s IP address.
If left blank, then every host on the network
cannot access the serial port.
Yes
Backup 1 IP addr IP address Backup host’s IP address Optional
Backup 2 IP addr IP address Backup host’s IP address Optional
Backup 3 IP addr IP address Backup host’s IP address Optional
TCP alive check
time
0-99 minute Specifies the time slice for checking whether the
TCP connection is alive. If there is no response,
CN2610 will reset the port and disconnect the
original connection.
Optional
3. Press Esc to return to PORT MENU.
Configuring Port Connection Settings—Port Menu [Line]
In PORT MENU [Line], you can set the line settings for the particular type of device being used.
1. From the MAIN MENU, use the arrow keys to select Port, and then press Enter.
CN2610-8 CN2610-8_19 V2.0 PORT MENU
------------------------------------------------------------------------------
Server [Port] seTting sAve Utility Restart Exit
Examine/modify async server ports configuration
Enter: select ESC: previous menu
2. From the PORT MENU, select Line, and then press Enter.
CN2610-8 CN2610-8_19 V2.0 PORT MENU
------------------------------------------------------------------------------
Mode [Line] mOdem Welcome_MSG Quit
Examine/modify asynchronous port configuration
Enter: select ESC: previous menu
Comments to this Manuals