CN2610 User’s Manual Getting Started
2-15
determine if the destination TCP/IP host is on the same subnet. If the address is on the same
subnet, a connection is established directly from the CN2610. Otherwise, the connection is
established through the “default gateway.” If this field is left ‘Blank’ the netmask will depend
on the default IP address class (which depends on the IP address itself). The netmask is
255.0.0.0 for class A, 255.255.0.0 for class B, and 255.255.255.0 for class C.
Default gateway IP address—This field contains the IP address of a router on the local
network. The default gateway is used when a packet is sent to an IP address that is not on the
subnet specified in CN2610’s local routing table.
Ethernet speed—If the Ethernet port is active, the Ethernet speed will be set automatically to
10BaseT or 100BaseT. This field cannot be modified.
Ethernet address—This field contains the hardware Ethernet address. This field cannot be
modified.
Server Configuration—Adv.
1. From the MAIN MENU, use the arrow keys to select Server, and then press Enter.
CN2610-8 CN2610-8_19 V2.0 MAIN MENU
------------------------------------------------------------------------------
[Server] Port seTting sAve Utility Restart Exit
Examine/modify async server node/table configuration
Enter: select ESC: previous menu
2. From the SERVER MENU, select Adv., and then press Enter.
CN2610-8 CN2610-8_19 V2.0 SERVER MENU
------------------------------------------------------------------------------
Info. Lan [Adv.] Host_table Route_table User_table Quit
Examine/modify async server basic configuration
Enter: select ESC: previous menu
3. The Adv. page contains input/display fields for RADIUS server IP, RADIUS key, UDP
port, Enable RADIUS accounting, SNMP community name, SNMP trap server IP
address, Ethernet IP forwarding, Routing protocol, TCP retransmission timeout, and
SIO data transfer timeout. Each item is described in detail below.
CN2610-8 CN2610-8_19 V2.0
------------------------------------------------------------------------------
Info. Lan [Adv.] Host_table Route_table User_table Quit
Examine/modify async server advance configuration
ESC: back to menu Enter: select
Radius server IP [ ]
RADIUS key [ ]
UDP port (1:1645 2:1812) [1]
Enable RADIUS accounting [no ]
SNMP community name [public ]
SNMP trap server IP address [ ]
Ethernet IP forwarding [no ]
Routing protocol [None ]
TCP retransmission timeout [ ] (range: 50 – 60000 ms)
SIO data transfer timeout [ ] (range: 0 – 1000 ms)
Comments to this Manuals